Hashiru LED running light indicatorpair ST07 M8 black, tinted glass

Description

Product Description: Hashiru LED Sequential Indicator Pair ST07 M8

Experience maximum safety with the Hashiru LED Sequential Indicator Pair ST07 M8. The sequential light effects drastically increase visibility. These durable indicators are perfect for any biker.

• Sequential Light Function: The LEDs light up one after the other from the inside out, increasing the attention of other road users and thus enhancing your safety.
• Increased Visibility: Thanks to the impressive conspicuity of the LED sequential lights, you will not be overlooked even in difficult lighting conditions.
• Vibration-Damping Rubber Base: A rubber base protects against vibrations and guarantees a longer lifespan of the indicators.
• Lightweight Plastic Housing: The sleek housing made of high-quality plastic ensures space-saving installation and a modern design.
• Technical Specifications: With 12 powerful LEDs per indicator, 12 volts, and 4.1 watts, they offer maximum performance with minimal energy consumption.
• Easy Installation: Thanks to the M8x1.25 thread and matching nut, installation is simple, and with suitable adapter cables, everything can be connected quickly.

Detailed Product Description:

Hashiru LED Sequential Indicator Pair ST07

Sequential LED indicators with LEDs lighting up one after the other (so-called running effect) for increased safety through better conspicuity in this flashing mode.

Details:

• when activated, the LEDs light up sequentially from the inside out until all are lit, then start again from the beginning
• the increased conspicuity results in a gain in safety
• lightweight plastic housing 
• with rubber base against vibrations for a long lifespan
• mounting via M8x1.25 thread and nut
• 12 powerful LEDs
• 12 volts, 4.1 watts

Dimensions (approx.):
Width x Height x Depth without thread: 80 x 20 x 15 mm
Foot diameter: 15 mm
Thread length: 18 mm
Cable length: 14 cm
Ø round plug sleeves: 3.5 mm
Weight: each 23 g

Cable Assignment:
yellow = positive indicator
black = ground

WARNING:
When using LED indicators on vehicles that originally do not use LED indicators, it may be necessary to replace the flasher relay and/or use resistors to reduce the flashing frequency to an acceptable level.

Options:

• if the legal distances cannot otherwise be maintained or the license plate is simply in the way, additional necessary extensions for the indicator arm can be used (Order No. 50170400860, 50170400870, or 50170400871)
• for easier connection without changes to the original indicator cables, there are corresponding adapter cables for many manufacturers/models (Order No. 50170003460 and following  as well as 50170502000 and following)
• if the installation is to take place instead of the original indicators, their mounting is usually too large - for many manufacturers/models there are suitable adapter plates with which the installation is then possible without problems (Order No. 50170100000 and following)
• with the adjustable resistor, also usable without problems for models with CAN-BUS system (Order number 50220000640)

Approval:
With E-mark for front and rear.
The indicators have an E-mark and do not require further paperwork.
They can therefore be installed without any problems, in accordance with installation regulations.

For motorcycles with E-approval (from around mid/end of the 90s) the following apply:
Minimum distance from indicator lens to indicator lens front/rear: 240/180 mm
Minimum distance from indicator lens to headlight lens: 75 mm
Maximum distance of rear indicator to the outermost end of the tail: 300 mm
Permissible installation height: 350 to 1200 mm
Geometric visibility inward/outward: 20/80 degrees
Geometric visibility up and down: 15 degrees
Permissible flashing frequency: 60 to 120 cycles per minute
For older models, vehicles introduced into traffic through individual approval, or non-EU countries, different measurements may apply.

Price per pair