Superbike handlebar 22mm 0084 steel 76x7,1cm chrome

Description

Hashiru Superbike steel handlebar 22 mm 0084

You think the original handlebar is too narrow or just too high?
Here is the classic handlebar with a comfortable width for your sporty relaxed sitting position.

Details:

• Made of very sturdy steel stube, high-quality chrome-plated steel
• With knurl in the clamping area and scaling between them for easy alignment.
• Makes most models handier and gives you a great sense of control for the bike.
• Suitable for handlebar mountings for handlebars with 22 mm outer diameter.

Measurements (approx.):
Width outer/inner edge: 770/761 mm
Height depending on positioning: 71-112 mm
Cranked to the back depending on positioning: 102-150 mm
Maximum width in the clamping area: 175 mm
Outer-Ø: 22 mm
Inner-Ø: 18 mm
Weight: 820 g

Options:

• Stencil for securing the holes for the security locking to prevent twisting of the handlebar switches (order number 50180808000)
• Suitable Hashiru handlebar ends (Order No. 60490000060 to 60490000066)

Certification (in Germany):
With vehicle type approval for many models (see attached PDF).
The provided vehicle type approval booklet must be carried along the ride.
A registration with the vehicle documents is possible for reasons of convenience, but not necessary.
WARNING: If your model is not listed in the supplied vehicle type approval, it will be used as a TÜV certificate - then a demonstration at the TÜV/Dekra is necessary upon consultation and immediately after the installation to get the confirmation of the proper installation and therefore the approval by individual approval required according to §19.2.

For our Swiss customers:
Please purchase this item in one of our Swiss branches, if possible.
Because of Swiss road traffic laws, you need a CH certificate (additional) for this technical item. This certificate can be obtained in one of our branches and will not be delivered with the item.
If you still wish to order this item online, please ensure that the motorcycle for which the component is intended is listed in the certificate accompanying the item. If this is not the case, the item is not eligible for return/exchange.
We will gladly answer any questions by e-mail or telephone via our hotline in Switzerland.

Price per piece

Installation comments:

The mounting of the handlebar is only possible on motorcycles which have corresponding risers with a handlebar clamp of Ø22.2 mm.
All cables and Bowden cables must be layed in a way that they are not bent or tensioned during any steering and deflection movements and that there is enough distance to chafing points.
The brake hoses must not fall below a bending radius of 40 mm. At full steering angle, with the engine running, on both sides, the engine speed must not change.
It is important to ensure that all controls on the handlebar are in the correct position, even when the steering angle is at full. The hand brake cylinder or the reservoir must be in functional working position.
It is important to pay attention to the free movement of the handlebar, its attachments and enough steering angle on each side. The handlebar must be easy to move from steering stop to steering stop.
After installation, perform a functional check of the brake, clutch, throttle, lights and horn.