to the cart »

Interesting offers:

Shad brake light kit for Adapterplate B29 for SH29/33/37/48/49/50

Order ID 70210200100
More Views

Shad brake light kit for Adapterplate B29 for SH29/33/37/48/49/50

Order ID 70210200100
  • keeps you safer on the road
  • E-marked for all motorbikes which use the E-mark for homologation
Description
Shipping & delivery
Product Questions

Shad brake light kit for adaptor plate

Additional brake light for attachment on the universal adaptor plates of Shad top boxes.

The raised position is usually significantly easier to see than the original and thus improves safety when you’re on the road.

To connect, you will need to tap into the original brake light cable.

With e-approval for motorcycles that are homologated via an e-approval (almost all models from the end of the 1990s).
Can be checked in line K of part I of the registration document (new registration document). If anything is entered here that begins with an “e”, then the additional brake light is permitted.
If nothing is entered here and therefore the motorbike has been homologated according to the German ABE (general type approval), then this brake light can be mounted as long as the complete light system is EU-tested (E test mark on the glass of the main headlight as well as on the rear light, the number plate light and the indicators).
It is not allowed on vehicles registered according to German law and lighting systems that still carry the “old” German “snake” test mark or other test marks (classic or antique bikes).
For models with the CAN bus system, the connection can lead to problems. Please consult your vehicle dealer beforehand.

Supplied without universal adaptor plate.

You may also be interested in the following product(s)

Reviews

Write Your Own Review

Passt super, Anschluß trickreich, Funktionstest siehe Kommentar
Review by Oliver1969
DIn Montage war schell und problemlos möglich. Beim Anschluß an das Bordnetz stellte ich fest das beide Stecker die an der Verkabelung vorhanden sind weiblich sind. Diese passten erst nachdem ich je einen etwas zusammengebogen hatte.
Der erste Funktionstest war leider negativ. Alle Kabel durch gemessen, sind ok. Das Original-Bremslicht leuchtet aber der Zusatz nicht! Beim direktem anklemmen an die Batterie leuchten beide. Als letzte Maßnahme den Motor gestartet und siehe da, sie gehen beide.
Die Spannung darf nicht unter 12 V sein sonst bleibt die Leuchte aus!!! (Posted on 1/25/2016)